Lawn Mower Blade Sharpener Inforamtion

One of the joys of owning a home is taking care of the yard.  For a well manicured and pretty yard, a lawn mower blade sharpener must be part of the yard tools owned.  Maintaining your mower’s engine will keep it going well, but it will not give a great cut on your lawn if the blades are in poor condition. 

Each spring, all house owners pack away the snow trowels and snow blowers in trade for rakes and lawn mowers as the recently grown grass starts to emerge.  Before getting on to the task of actually mowing grass, the mower must be inspected and maintained after being put away away for the previous 6 months.  A good cleaning, fresh oil and gas and a close investigation of the blades should occur at this time.  If the blade show chips, dents or peculiar bending, it should be replaced.  Using the mower will naturally, over time, dull the blade and spring time maintenance should include getting those blades in tip top shape. 

Using the turf mower blade sharpener of your choosing, you can simply get the blade back in like new condition.  First, the spark plug wire must be removed from the mower.  The engine will really start if the blade is revolved by hand while the spark plug is still connected.  Place the mower on its side, being careful to keep the side housing the carburetor and the air filter facing upward to avoid any contamination of fuel or oil in the air filter.  Loosening the center bolt will allow you to get rid of the blade. 

Once the blade is removed, it should be marked in a way the owner will know the way to properly reinstall the blade.  After a good examination of the blade to guarantee it is in reasonable condition, you are ready to sharpen the blade.  There are some sorts of sharpeners that may be used, depending on personal taste.  A combo grinder / sharpener may make the job simpler, but is a reasonably expensive investment.  An easy hand file is more than sufficient to do the job at a much lower cost.  Begin at the top side of the sharp edge of the blade, using the push stroke to chop into the steel.  It should take only about 50 strokes total to finish the task. 

Keeping your yard clean cut is healthy and gorgeous ; made possible with the investment of a little time using the grass mower blade sharpener to get that blade in cutting order.